• Registered: 2011-03-14
  • Posts: 3

Topic: Reg:Writing ID to Mifare classic 1K card

Hi,
Good day to all!

I am using Mifare classic 1K card in one of my RFID based project for college.
I want to store register number of the student in the tag , so that the reader should read this number for authentication & link to his database in back-end PC .

I tried to change the ID of the Tag its not possible to change . reader will always reads the deafault ID (58C4E09C) .

How can I store the data in the  tag so that the reader  will read at the data ( register number )whatever i stored during authentication time.

Please help...
Regards,
Girish Kuamr

  • Registered: 2009-07-15
  • Posts: 57

Re: Reg:Writing ID to Mifare classic 1K card

Have a look here: http://www.libnfc.org/documentation/har … s/iso14443.
You will find a link to NXP/Mifare classic 1K and then you will find specs.

  • Registered: 2011-03-14
  • Posts: 3

Re: Reg:Writing ID to Mifare classic 1K card

Thanks for your Kind Concern.But the link gives just brief introduction of Mifare classic 1K card .
Regards,
Girish Kumar

  • Registered: 2009-07-15
  • Posts: 57

Re: Reg:Writing ID to Mifare classic 1K card

In that page you will find a link with complete specs of Mifare Classic 1K card.
You need it to understand that you cannot change ID of a tag and how to authenticate and read/write values.

  • Registered: 2011-03-14
  • Posts: 3

Re: Reg:Writing ID to Mifare classic 1K card

Thanks Rleo!
Regards,
Girish Kumar

  • ika
  • New member
  • Offline
  • Registered: 2011-08-24
  • Posts: 3

Re: Reg:Writing ID to Mifare classic 1K card

Sorry..may i know how about if i failed to get the serial number in the tag (mifare card 1k)..Means,when i plug in,it connected but function not supported when get the ATS..after store the data and get the UID.

I'm using ACR122U tool to test the tag reader.